Creepy Hand Hook – Halloween

Creepy Hand Hook – stylish coat & helmet hook - Halloween (Remix)

Just in time for Halloween, these hands crawl directly out of the wall – perfect for holding jackets or helmets with a little scare!

The underlying hand model comes from an older, freely available 3D design, which I have technically revised and adapted for everyday use

Remix Note

Remix of an older 3D hand model from thangs. The model has been technically revised

The base was split with a dovetail cut and the resulting wall mount was extended with a concealed screw holder

The fingers were provided with a modifier to achieve higher stability in the upper area
Nevertheless... Don't overdo it ;-)

Attention!
The fingernails are very sharp!
Absolute caution is required here – these hands are decorative but not harmless

Do not under any circumstances mount the hands at eye level!

Print Settings (Main Body)

• Layer height: 0.12 mm (High Quality Profile @Bambu X1C)
• Wall lines: 4
• Top layers: 6 (0.6 mm)
• Bottom layers: 5 (0.5 mm)
• Infill density: 20 % (Triangle pattern)
• Infill pattern: Triangles
• Material: PLA or PETG recommended
• Supports: only on the build plate contact area

Print Settings for the Modifier (Finger Area)

• Layer height: 0.12 mm (identical to the rest)
• Wall lines: 8
• Infill density: 30 % (Gyroid)
• Area: local reinforcement from the finger joints outwards

Color Design & Filament Choice

Printed with Ziro Multicolor Matt PLA (color shade „Matt Shadow“) – a two to three-color co-extrusion filament in black and white - available on Amazon

I arranged the right and left hands on two separate build plates each, so that they receive a mirrored color distribution. This makes them appear like two identical hands next to each other, forming a harmonious pair visually