Accessories for Harbor Freight mini toolboxes - Free 3D Print Model

Search models, users, collections, and posts

Remixed by

nealc10

Tools>Organizers

IP Report

Print Profile(4)

All

H2D

H2C

X1 Carbon

P1P

X1E

P2S

P1S

H2D Pro

A1 mini

H2S

0.2mm layer, 2 walls, 15% infill

Designer

2.9 h

1 plate

4.9(111)

0.16mm layer, 2 walls, 15% infill, small side tray

Designer

57 min

1 plate

5.0(31)

0.16mm layer, 2 walls, 15% infill Handle, one color

Designer

52 min

1 plate

4.9(31)

0.16mm layer, 2 walls, 15% infill, 2 color

Designer

1.4 h

1 plate

4.7(22)

Open in Bambu Studio

Boost

878

2648

257

2.6 k

1.3 k

Released

Description

I downloaded the BB 3D Garage Harbor Freight Mini Toolbox Cart and the Gilded_Dragon Harbor Freight Mini Tool Box Shelf to convert my HF US General mini toolbox to a mini toolbox service cart. To make the cart a little more authentic I wanted to add a side tray, handle, and smaller tray to better simulate the Harbor Freight Service carts.

The Gilded Dragon tray was almost perfect, but didn't quite fit this specific tool cart model. I modified the support brackets to be closer together to fit the BB 3D Garage Toolbox cart. The changes also allow the side shelf to be printed with significantly less supports (see the slicer screen shot). This file should be printed with a brim and with tree supports enabled.

I also created tool cart side handle. 3MF files for a 1 color and 2 color version are available. The ends of the handle are a different color in the 2 color version, allowing a better match to the real Harbor Freight two color handles. No supports are needed, but I recommend using a brim.

The third piece is a small tray with slots for up to four (4) 8mm x 3 mm magnets, to attach the tray to the side of the mini toolbox. The slots are slightly large, so please glue the magnets in place. Two magnets are adequate, four will make the tray “snap ” into place. If you don't have magnets, double stick tape will work.

I printed from PLA using 0.16mm Balanced strenght settings in Bambu Slicer. PETG, ASA, ABS, etc all should work. These parts, and the linked above designs will also work with Lowes Kobalt mini toolboxes.

NOTE

The front edge of the top tray of some mini tool boxes a lip along the inside edge of the top tray. The large tray and handle posted here won't fit in this purple box. See screen shot below. If you have a box like this, reduce the width by about 2% in slicer so the parts will accomodate this lip.

I've used 1" casters purchased from Amazon, have used 3 brands so far

https://www.amazon.com/dp/B0F669MP4Y?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1

https://www.amazon.com/dp/B00F5PNISQ?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_4

https://www.amazon.com/dp/B0D5D9V83N?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1

See screen shot below of the differences.