Fallout Deathclaw Gauntlet V2 + Extra Claw Mod

Revamped the original design to be more sturdy and added the extra claw mod. The plates have different ones depending if you want the two or three claw version. The A1 mini plates have the claw split one additional time to fit the build volume. 

Plastic used:

Bambu Basics Beige PLA

Bambu Basics Black PLA

Bambu Basics Dark Grey

Generic Black TPU

Glue the cuff front back and mid together making sure the holes for pins line up

Glue the claws together with the clamps over the seams (the rear clamps are the smaller ones and the fronts have the bigger openings for the grip bar.

Glue the pump on the grip with the hole facing down towards the loops on the cuff

Run the TPU wire through the loops and trim off as much as needed so it fits into the pump then glue

Glue the pins through the cuff into the claws

Glue the handle into the front clamps

If doing the 3 claw version glue the 2 additional pins to the sides and top

There is a V1 conversion profile if you printed the previous model you can upgrade it without having to do a complete rebuild. It does require a minor amount of drilling for pins. It has the connection parts for the front clamps as stand alone. Assemble with the top claw and use the pins to help line up the connectors then glue them in place.