Wall mount for Worx WA3880 charger

Hello,

I wanted to hang the charger for the Worx 20V batteries (WA3880) on the wall so that the batteries could always be charged within reach.
The holder, charger, and batteries should be in the tool area to be readily accessible.

Unfortunately, I couldn't find a suitable holder in the relevant online data sources. So I created one myself.
It is a simple plate (with various screw holes (preferably countersunk screws, which should not be tightened too much) and a few “nubs”).

At the top there are two mushroom-head nubs to hang the charger in the existing elongated holes. Below are two simple nubs that fit into the foot holes of the charger. This allows the charger to first be hung in the elongated holes at the top, then pushed down and locked with its feet onto the lower nubs.
This way, the charger is not lifted out of the elongated holes when removing the batteries (upwards), but can still be easily removed for use elsewhere if it is first pulled slightly away from the wall at the bottom.