Search models, users, collections, and posts
Philips HueGo Holder Acoustic Panel
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.7 h
1 plate
Open in Bambu Studio
Boost
15
81
2
1
49
26
Released
Description
Content has been automatically translated.
Hello.
I built a holder for the Philips Hue Go so that the lamp can be attached to an acoustic panel without screws.
The holder consists of 3 parts. The first part is twisted between the slats (it's easier if the felt is pressed in at that spot with a spoon handle). The second part is simply pushed into the guide from above. The third part is placed onto the pin and screwed tight from below with an M8 screw (I would screw in the M8 screw once by itself beforehand).
It works in PLA, but PETG is more stable.
Printed in PLA with a 0.4 mm nozzle
20% infill
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)