Gravity Knife - Little Shark / Print in Place / No Assembly Required / Print and Play

💁🏻If you encounter printing problems, please don't rush to rate~🙏🏻

Leave a comment and upload photos 🫶🏻I will help you solve it immediately!

Update Log:

2025-11-03 Version 1.5 added:

• Increased corner seam distance: Reduced adhesion probability (If it still adheres and cannot unfold, it is recommended to calibrate your machine or refer to Print Quality Solutions to troubleshoot the cause.)
• Increased brim to model gap to 0.15 mm: Easier to tear off the brim (If difficult to tear, it can be appropriately increased, which may also increase the probability of model shaking. For A series models, please choose carefully.)

Print in Place⭐️No assembly required⭐️Print and play

Model test material: Bambu Lab PLA Matte and PLA Basic

Two sizes:

• Small knife: 22.4 x 45.6 x 67.2 mm
• Large knife: 28 x 57 x 84 mm

Note: Brim is required to prevent it from falling over when printing vertically and to increase printing success rate. (Profile has been added, can be canceled if glue is applied)

Note: Brim (dark blue) needs to be manually torn off after printing is complete

⭐️Gravity Shark Knife (Click to view)⭐️

⭐️OTF Switchblade (Click to view)⭐️

If you encounter any problems during printing, feel free to leave a comment or send me a private message.
I will assist you in identifying the problem and providing a solution as soon as possible.🙏🏻

For faster processing, you can attach:

• Photos of the problem📷✨
• Filament brand and model🧵
• Printing parameters (layer height/temperature/speed, etc.)🔧

Let's work together to ensure you can complete your prints smoothly and with high quality.😊

💡Click to view《Print Quality Solutions》 to troubleshoot problems 💡

Ratings are very important to creators   You can read《Rating Guidelines》 then rate