Unitree Go2 Top Ports Access

Replacement for the little plate to have easy access to the connectors on the back of the Go2
2 Versions:
-RJ45 + XT30
-RJ45 Only

hardware needed:
2x RX-M3x5.7 heat inserts (I used Ruthex M3 Inserts)

Optional: replace the two philips screws by two M3x8 Hex socket or Torx screws
the stock screws heads can already be cammed-out from factory and/or easy to strip

Grey Matte PLA works just fine, but you may consider PETG if you lift the Go2 with the belt (not recommended even with stock plate)

Personally, to lift it i always Lock up the limbs of the Go2 first, then I carry it by the body or the legs