Halloween Ghost 4 – The Seizer

👻 Halloween Ghost 4 – The Seizer

The Seizer is all menace and motion… frozen mid-lunge, fingers stretched wide as if moments from grabbing its prey. The forward reach and hollow scream give it a powerful presence, even at smaller sizes. Designed for easy wall mounting, this spirit strikes fast and lingers long.

A perfect addition to your Halloween Ghost series… subtle until it's suddenly right in your face.

🛠️ Print profile included:

• 2 walls
• Top surface pattern: Monotonic line
• 5% gyroid with infill combination

Plates:

1. 100mm 0.20 layer
2. 150mm 0.20 layer
3. 100mm variable layer
4. 100mm fuzzy skin
   • Top surface: Hilbert Curve
   • All walls, distance 0.2, thickness 0.1

Key Printing Tips:

• Disable “Strength → Detect Thin Wall” → gives smoother, cleaner surfaces on detailed parts.
• Always check the slicing preview in Bambu Studio before starting the print.
• Support removal trick: Cut supports into small chunks first, then gently loosen → they usually pop off cleanly without damage.
• Some plates use lots of supports, if so → for reliable prints use these filament settings:
  • Filament Overrides
    • Z Hop When Retract: 0.6 mm
    • Z Hop Type: Spiral
    • Travel Distance Threshold: 1 mm
    • ✅ Enable Retract When Changing Layer
  • Also, disable these settings in Bambu Studio if Variable Layer height is used:
    • Supports
      • ❌ Disable Independent Support Layer Height
    • Others
      • ❌ Disable Reduce Infill Retraction
    • I’ve found that a 0.15 mm top Z distance works best when printing with variable layer height.

Happy printing! Can't wait to see photos of your prints! If you're scaling, experimenting or encounter any issues, let me know → your input helps the next iteration. Please share your feedback for any rating below ⭐⭐⭐⭐⭐ so we can work on improving, thank you!