Search models, users, collections, and posts
Lube Applicator
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
11 min
1 plate
Open in Bambu Studio
Boost
3
8
5
0
19
12
Released
Description
This is my attempt at a minimal lube applicator. I looked at others, but they did not fit my tube of Permatex Grease plus I thought there was a lot of grease filling the void between the tube of lube and the tip of the applicator which would never be recovered. I thought since the requirement to grease the z screw was 3 months I would go for a simplistic design that delivers grease but doesn't have a lot of loss in the application.
Also, the applicator takes about 10 minutes to print and can be thrown out after use, so you are not stuck dealing with storing a continuing mess. I have included the step file so you can avoid the issues with different versions of Bambu Studio.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (5)