LightStone Bracelet/Cuff - Nova Bracelet Replica

My daughter was/is obsessed with the Zombie movies. Of course she wanted to dress just like Nova from the Zombies 4 movie. With the help of a AI program I was able to make this replica. I'm still learning design and building so some of the design is altered using modifiers in Bambu Studio vs redesigning for better aesthetics.  

You may have to manipulate the sizes to fit. My daughter wanted as tight fitting as possible, so I made it more of a cuff when it prints. The first versions were very thin when the AI program helped create it. I made it a little thicker. you are going to have some clean up around the support areas depending on how you position it. I printed mine vertically to try and increase the strength of it. I printed in PETG. I noticed that some of the first attempts to print the cuff would break at some of the layers. So, I made little flat strips of filament that I super glued inside to create more support, this helped prevent the cuff from breaking when my daughter would stretch it to put her hand in. 

I had to remind my daughter, I'm not Disney and didn't have Disney money so its not IDENTICAL to Nova's in the movie but it is pretty damn close. She wore it to the Worlds Collide concert recently for the movie crossover. She said she rcv'd so many compliments on it so I guess although its not identical, its pretty close. 

Filaments used were Flashforge Gold Silk PETG and Sunlu Red Transparent PETG. 

Good Luck with it and I hope your little ones can enjoy it as much as my daughter has!!!