Kentrosaurus hueforge

For Personal Use Only: Print as many as you like for yourself
Commercial License : Not allowed unless you hold a valid license on Makerworld or from my Patreon

Kentrosaurus was a herbivorous dinosaur that lived during the Late Jurassic period, around 155 million years ago, in what is now Tanzania. It was a close relative of the more famous Stegosaurus and belonged to the same family, the Stegosauridae. Although smaller than its relatives, measuring roughly 4.5 meters in length, Kentrosaurus was one of the most strikingly armed dinosaurs of its time, covered with an elaborate arrangement of plates and spikes that ran along its back and tail. Its body was low and heavy, supported by short, sturdy legs, giving it a slow but stable gait suited to grazing on low vegetation such as ferns, cycads, and early conifers.

The most distinctive feature of Kentrosaurus was its array of defensive spines. The front half of its body bore pairs of small, flat plates along the neck and shoulders, which gradually transitioned into long, sharp spikes along the hips and tail. The tail itself ended in several elongated spikes that could have been used as a formidable weapon against predators like Allosaurus or Ceratosaurus. These spikes were arranged in pairs and could swing with great force, suggesting that Kentrosaurus relied heavily on them for defense rather than speed or agility. Its small, elongated skull contained a beak-like mouth ideal for cropping tough plant material, and its teeth were shaped for slicing vegetation rather than grinding it.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 170x170mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.24mm and the Actual Thickness is 2.24mm

    #151715 PLA Deeplee Black  Transmission Distance: 0.1
    #626f89 PLA Deeplee Blue Grey  Transmission Distance: 2.5
    #8e8f8f PLA Deeplee Light Grey  Transmission Distance: 1
    #ffffff PLA Deeplee White  Transmission Distance: 6.1
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #8 (0.72mm) swap to Blue Grey
    At layer #15 (1.28mm) swap to Light Grey
    At layer #20 (1.68mm) swap to White for the rest.

You can see my other Dinosaur pictures here in this collection: https://makerworld.com/en/collections/14092197-dinosaur-hueforge

You can Download a stand I have designed to fit  my Hueforge Artwork WITH a border at https://makerworld.com/en/models/1873510-hueforge-display-stand-for-prints-with-borders#profileId-2005518 or for Hueforges WITHOUT a border use this one: https://makerworld.com/en/models/1872617-hueforge-display-stand-for-prints-without-borders#profileId-2004540

If you print this model, please upload a photo of your result, Rate the print and leave a Review. 

Not only does it inspire others in the community, I'd love to see what people have done!