Search models, users, collections, and posts
CBE Bow Sight Handle
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
24 min
1 plate
Open in Bambu Studio
Boost
4
8
0
0
5
2
Released
Description
I have created a handle for CBE Bow Sights. It has been tested on the Trek Pro but should fit other models. It allows greater ease in adjusting the sight rather than the factory knob that only has the 3 points. It snaps right over the end of the factory handle. The print profile I uploaded should already be set for PETG and at 97% scale. The 97% scale seemed to work the best, it didn't rattle and fit nice and snug.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)