Star Wars Revenge of the Sith - HueForge Poster

🪐 Presentation

Here’s my Hueforge print of a minimalist poster of Star Wars: Episode III – Revenge of the Sith.

⚙️ Print Settings

Printed at 100% infill with a layer height of 0.08 mm and a base layer of 0.16 mm.
The model measures 150 × 225 mm.

You can print at higher layer heights below the Base Thickness of 0.48 mm.
Max allowed Thickness: 2.24 mm
Actual Thickness: 2.16 mm

Filaments Used:

• PLA BambuLab Matte Charcoal - Transmission 0.6
• PLA BambuLab Basic Red - Transmission 4
• PLA Sunlu Beige - Transmission 7.4
• PLA BambuLab Basic Jade White -Transmission 5

Swap Instructions:

• Start with Charcoal
• Layer #9  (0.80 mm) → swap to Red
• Layer #14 (1.20 mm) → swap to Beige
• Layer #21 (1.76 mm) → swap to Jade White for the rest

💡 If you don’t have an AMS, add a pause at each color change so you can swap filaments manually.

⚠️ This print is slightly top-heavy, be careful when handling it. Avoid holding it only by the lower black section, as it has fewer layers and could bend or break under pressure.
⚠️ If you want to resize it, DO NOT TOUCH THE Z-AXIS or the colors will not be aligned properly anymore.

🧵 Other Filament Options

You can choose any black filament with a low TD for this print.
As for the beige tone, PLA BambuLab Basic Beige should provide a very similar result to the PLA Sunlu Beige used here.

🖼 Frame

I'm using the “Hueforge Frame by Canadian Gamer 150x225" printed in PLA+ Sunlu Roasted Chestnut, you can find it here: https://makerworld.com/en/models/709013-slim-square-friction-fit-frame#profileId-639290

🌌 Star Wars Collection

This print is part of my ongoing Star Wars Hueforge poster collection, where I’ll be recreating the first 6 episode minimalist poster (not sure about doing the last 3): https://makerworld.com/en/collections/14090020-star-wars-hueforge