Photone paper diffusor ppfd

Photone App Light Diffuser (Phone Clip System)

This 3D-printed diffuser is designed specifically for the Photone mobile App and helps achieve more accurate light measurements using your smartphone.

🔹 Features & Details:

• Easily clips onto any phone – universal fit.(Without a case)
• Optimized for use with the Photone App → In the app settings, enable “Paper Diffuser” mode.
• No supports required – ready to print right away.
• To install the paper, insert the full sheet into the slot and then tear it off along the edge of the printed model – the edge acts as a designed tear line.
• If the paper doesn’t fit perfectly into the slot, you can carefully widen it with a knife.

🧱 Recommended Print Settings:

• Material: PLA or PETG
• Layer height: 0.2 mm
• Infill: 15–20 %
• No supports

💡 Note:
The model is designed to use standard printer paper (e.g., 80 g/m²) as a diffuser. Also important for the App and recommended by photone.