Makerflo Whiskey Rocks Glass Xtool Jig

This is a jig for the Makerflo 8oz Whiskey Rocks Glass. I made this for my Xtool P2s to allow the glass to sit parallel to the honeycomb panel so I could engrave “flat surface” vs “curved surface”. 

This is an easy print with no supports needed. You might need to enable painted brim ears on the small pins. I did not need to on my X1c but might be required on a bedslinger like the A1 mini.

There are 2 pieces.

• The jig has a minimal 9mm lift 
• The baseplate, which is designed to be used as a support to keep the jig in place, makes it easy to rotate or switch the glass without losing the laser position.