Bambu Lab P2S, X2D Riser

Recently purchased Bambu Lab P2S, the PTFE tube on the previous P1S print head would also scratch the glass. I downloaded several clip-on hangers, but they would fall off after a while, or cause the PTFE tube to bend too much, affecting feed. I searched for risers, but those designed solely to prevent scratching weren't quite suitable. Most risers were too tall and included drawers, which I didn't need. So I simply designed a minimalist version, purely to raise it by 15mm, without any ventilation hangers. Just to prevent scratching the glass. If friends need different heights, they can leave a message and I'll modify and upload several different heights. There are no clips at the cuts; if it needs to be fixed, just use glue. For the part that contacts the glass, you can buy EVA foam strips and apply them around it. (Just got an X2D, and I tried putting the original P2S riser on it; it's a bit loose but fully usable. I'll adjust it to be a bit tighter later, and also add front parts and side hooks.)