Footpeg rubbers for Ural (Other) motorcycle

Replica of the original footpeg rubber used on Ural motorcycles. Designed to fit onto the standard metal peg and improve grip and vibration damping.
Printed from TPU flexible filament (recommended hardness 95A) for a firm fit and long service life.

Versions:

1. Version A:
   • Height – 110 mm
   • Width – 53 mm
   • Inner hole – Ø 16 mm (round)
2. Version B:
   • Height – 120 mm
   • Width – 53 mm
   • Inner hole – 15 × 15 mm (square)

Print settings:

• Material: TPU / TPE (shore 95A)
• Infill: 35-40 %
• Layer height: 0.2 mm
• Supports: ON
• Orientation: vertical, flange down
• Use glue stick or brim for better bed adhesion

Note:

After printing, rinse the part in warm soapy water to remove adhesion residue and restore flexibility.