HauntedWeen Hueforge

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.24mm and the Actual Thickness is 2.24mm

    #000000 PLA BambuLab Matte Charcoal  Transmission Distance: 0.6
    #c00d1e PLA BambuLab Basic Red  Transmission Distance: 4
    #a6a9aa PLA BambuLab Basic Silver  Transmission Distance: 0.5
    #ffffff PLA BambuLab Matte Ivory White  Transmission Distance: 3.5
This print uses 4 unique filaments

Swap Instructions:
    Start with Charcoal
    At layer #8 (0.72mm) swap to Red
    At layer #16 (1.36mm) swap to Silver

Border Only Colors from here until the end.
    At layer #20 (1.68mm) swap to Ivory White for the rest.