Mitsubishi Outlander 4WD Knob Bezel

My knob bezel cracked so I thought I may as well design and print a new one.

I used snug supports which seemed to work the best.

I also recommend using ironing on all top layers for a smother finish.

There are 2 models, Outlander4WD is the original and designed to the exact same size as the original but I made Outlander4WD2 to thicked up the top section so it prints and looks better, I recommend using the second one.

This one is currently printed in eSun PLA+ to test how well it holds up in the heat of the car. 

So far it's held up perfectly in the tropical sun, I have since printed a new one in resin.