Case BetaFPV Meteor75 Pro ViFly WhoopStor 3/ Hexa

🧳 Case for BetaFPV Meteor 75 Pro – ViFly WhoopStor 3 Edition ( BetaFPV Hexacharger )
(with revised accessory compartment in the lid)

A well-designed, compact transport solution for your micro whoops including charger, accessories, and batteries – now in the completely revised version with optimized structure, improved ventilation, and integrated battery clamp

Compatible with the ViFly WhoopStor 3 and the BetaFPV Hexacharger charger.

✅ Tested Compatibility

Successfully tested with:

BetaFPV Air 65 (insert Air 65)

BetaFPV Air 65 II (insert Air 65II)

BetaFPV Air 75 (insert Air 75)

BetaFPV Air 75 II (insert Air 75 II)

BetaFPV Meteor 65 Pro (insert Meteor 65 Pro)

BetaFPV Meteor 75 Pro

Mobula 6 (insert Air 65)

HDzero M8 Freestyle

Secure fit thanks to precisely fitting inserts – optimally protected during transport

🔌 Perfectly tailored for the charger

Optimized for the ViFly WhoopStor 3 charger:

Precise fit in the case

Charging possible directly in the case

Retractable front panel

All connections freely accessible

Revised airflow channels for better ventilation

Also compatible with the BetaFPV Hexacharger charger.
For this, a specially designed insert is already integrated into the main print file. This slightly elevates the charger to improve airflow and simultaneously prevent it from sliding in the case

Ideal for on the go or quick battery changes at the spot

What has been improved

This version has been constructively further developed and optimized in many details:

📦 Parts/tools compartment enlarged by 3.5 mm

🔩 Hinge holes (lid side) minimally adjusted

🪶 Additional chamfer at the rear (lid & bottom)

🌬 Revised airflow channels

🔐 Locking hole slightly enlarged

🔋 Space for up to 10 batteries

🔋 Battery clamp – new & old version included

The battery clamp V2 is now an integral part of the standard print file:

More contact pressure

Secure hold

Tested with 550 mAh Lava

Also tested with 450 mAh batteries

The original battery clamp is still included in the print file and can be used if needed

🧩 Print profiles

🟦 Basic Case (with integrated inlet)
→ suitable for Meteor 75 Pro & Meteor 65 Pro

🟥 Air 65 / Air 75 / Air 75 II Inlet
→ separate print profile

🧷 Required hardware

3 × M3 screws (20 mm) – hinges

2 × M3 screws (30 mm) – latch

🖨 Recommended print settings

Material: PLA+, PETG or ASA

Layer height: 0.2 mm

Infill: 15–20 %

Support: not required

Print time: approx 6–8 hours

✨ In short

✔ Tested with 8 Whoops

✔ Charger usable directly in the case

✔ Compatible with ViFly WhoopStor 3 & BetaFPV Hexacharger

✔ Space for up to 10 batteries

✔ V2 battery clamp integrated

✔ Old clamp still available

✔ Stable, functional, and well-designed

Ready for Take-Off 🚁

Note:
My logo is integrated into the model. This serves to protect against unauthorized commercial sale.
Thank you for your understanding