Search models, users, collections, and posts
GEPRC Darkstar 16 replacement hood
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
13 min
1 plate
Open in Bambu Studio
Boost
3
6
0
1
6
3
Released
Description
Solves the issue with the original hood being loose and flipping up resulting in almost no protection for the O4 pro lens. This design
- Sits about 7mm lower
- Allows full range of angles (the original restricts the higher angles)
- Restricts the hood from flipping upwards hence better protecting the O4 pro lens
With PLA, this comes in at 1.8g vs. 1.3 for the original
*Note: shortened hood from original to clear lens
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (0)