Purple viper scx24 tremor v2 remix

So I entered a competition with the original Tremor V2 by depep1 (Came 9th out of 25) and noticed the breakover wasn't quite enough. I spent 2 days in fusion 360 and onshape to add a 20 degree breakover angle and redesign the skid plate so you don't have to.

I printed this on an A1 mini in Sunlu PETG so it should fit on ay print bed, I have also added supports and brims where needed. Be aware the supports for the battery tray can be a little difficult to remove without nippers I did have some success using a pocket knife to remove them but nippers made it so much easier.

 This is designed for use with the Injora Purple Viper I have added a cover to the motor so wires don't rub on it but have left a viewing window on the side. As for electronics I used the MBL32 v2 from Injora that comes in the purple viper combo kit and a Radiolink R4FGM receiver with the Radiolink RC6GS, it is a tight fit but it does fit after raising the roofline by about 2 mm. The hardware from the stock SCX24 is all you need for hardware plus some 14mm xm1.4 hex head screws available from most hobby shops or Amazon (the same ones used in the top of the diff covers).

 Remixes are welcome as is any feedback.

I haven't tried this in competition just yet but from running it around the house it seems to perform very well