Battleship working waverider
Print Profile(2)
Description
This is a working battleship wave rider. the design is based off a flowrider. It works with your normal hose outside you house. you may want to hold the part that attaches to the hose and sprays water to start as the quick pressure might push it back. THE PART WHERE THE WATER COMES OUT(NOT THE PART THAT SCREWS INTO THE HOSE) MUST BE PRINTED WITH A .2 NOZZEL. To get the battleship on the sliding rail just place it in the rail sideways and than twist it. This will make a mess so I recommend using it outside. It may take a few seconds for the pressure to fully get threw the hose before working.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (2)