Search models, users, collections, and posts
Pegasus Work Table Clamp Dogs
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
57 min
1 plate
Open in Bambu Studio
Boost
13
53
0
0
29
14
Released
Description
I created a version of the Clamp Dogs for the Worx Pegasus work table and saw horse.
The diameter for the peg is 20mm at its widest point, including the small notches. It should flex down to just over 19mm for a tight fit.
It has the cutouts to save on filament and it's designed to be printed without supports, ideally at an angle from the sloped ridges at the top. You can select the auto-orientation in Bambu Studio. So far, I have only tested it with PLA, printed with 3 walls, 15% Gyroid infill.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)