Search models, users, collections, and posts
Harry Potter Glasses - No Additional Hardware Reqd
Remixed by
IP Report
Print Profile(1)
0.12mm layer, 2 walls, 15% infill
Designer
57 min
1 plate
Open in Bambu Studio
Boost
157
485
46
6
1.2 k
936
Released
Bill of Materials
Bambu Filaments
Select all
Description
Simple Harry Potter Costume Glasses - No Hardware Required
This remix takes the frames and arms of the original and modifies the following (all in the slicer)
- Scales the arms in to lengthen them to approx 135mm
- Adds Cones (solids) to the arms and ramp (negatives) to the frames to allow for assembly of the arms to the frames without any additional screws or hardware.
The size of the cones and angles of the ramps can be modified to allow for various printer tolerances. When I printed on my P1S with PLA Matte, the fit was very tight but allowed for assembly with some wiggling and pressure.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (46)