Dota2|Anti-Mage|AM|Persona|Sakura Tribe Apostate|White Model|Non-AI

Attention This model is not recommended for any beginner printer

I have released an export tutorial, you can click here to watch it and try exporting the model yourself If it's useful, you can boost me, thank you

Please confirm the following issues before printing

1. Because this model is very complex, supports are extremely difficult to remove without patience, it's easy to damage the model, including but not limited to, hair and weapon accessories you can check my own examples
    

   

2. 

3. I printed A1 mini twice the first time, because it was too small, the quality felt very poor and the supports were hard to remove the second time, the back ribbon support toppled, directly resulting in spaghetti
4. The detail of the Dota model itself largely relies on textures, so the quality is far from what it looks like in the game also, the overhang effect looks very bad when viewed from below, which is a common issue with 3D printing and can't be helped

If you can accept the above minor flaws

Recommended for printing, after all, there aren't many Dota 2 models in the community

I will export more models when I have time (exporting is definitely not just a click, it takes a long time to adjust details) if there are any models you want, you can also leave a comment I will consider likes and feasibility to make them finally, thank you everyone