Crosman Picatinny End Cap

This model is to allow you to add a picatinny  stock to your crosman 1377/1322. Its scaled to fit snugly, but without having to sand down. 

I saw a model on here (https://makerworld.com/en/models/1017511-crosman-1322-rear-cap-with-rail#profileId-998059), and while it looked good, was not quite perfect. 

My model has been designed and tested and retested to ensure a snug fit, and that there is no power loss from the stock end cap. 

The design is printed with multiple walls, on its side and is exceptionally strong.  

As a bonus, you can also add a bit of paracord to make a sling loop.

NOTE: You will need to use a 1/8 drill bit to open up the holes. I recommend inserting the end cap into your 1377/1322 as far as it will go and drill out the first hole, then rotate the plug 180 degrees and drill the second hole. From there you can take your stock screw and cut threads in by manually screwing in.