FCR Double Funnel with holes no support

For Keihin FCR Double Air Funnel. A small section has been removed at the edge of each funnel so both funnels can be mounted side by side on dual carburetors. The bolt holes are angled at 15° for an Allen key. The overall height is 30 mm, but you can adjust it in the slicer by scaling to the desired height. After scaling, lower the model so the flange thickness is exactly 5 mm in total.
In the slicer, use “Scaling” and scale only the Z axis if you want to change height without affecting the inlet geometry. Then move the air funnel under the bed so the flange will be 5 mm thickness.