Search models, users, collections, and posts
Cover for ground sleeve for Prostor P6
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
53 min
1 plate
Open in Bambu Studio
Boost
1
0
0
0
1
0
Released
Bill of Materials
List other parts
- Schrauben x 2: 30x4 Holzschrauben mit Senkkopf
Description
Content has been automatically translated.
A cover for the ground sleeve for the Prostor P6. This is needed so that no dirt falls into the small openings around the large hole. I would recommend printing the cover from ASA, but unfortunately, I didn't have any, so I first printed it with white PLA, but I will print it again in gray ASA and then replace it. I hope this model helps you.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)