COWAY AIRMEGA 150 Air Filter Flange for Printer

This is a big print - 15 hours on the P1S. For the P1S it required the procedure to enable the full printing dimensions to be enabled.

Prints without support - just slowly because of the overhang.

Depending on the printer you have, so long as it has a rear facing 80-100mm exhaust fan, you should be able to position this flange so that it lines up with the exhaust. The Coway Airmega 150 is a great air filter for 3d printing because it has a sensor to ramp up it's fan whenever it detects poor air quality. The air filter will create negative pressure in the printer, ensuring that all impurities will pass through the air purifier.

The studs align perfectly with the perforations on the Coway Airmega 150 air filter. I'd recommend taking the front door of the filter off, gently pressing the studs into the right position on the filter and then it should be held tightly enough so that it will stay on forever. Just slide the flange up against the exhaust location and you have an instant high volume air filter for your printer.