Charmander Chibi

New model, this time Charmander Chibi, I hope you like it

I'm leaving you two files, one for AMS and one Multipart for use without AMS 

I recommend printing the parts in the orientation I left in the profile, that's how they print best, especially the white parts of the eyes

Regarding the color of the eyes, I used a dark green Bambu Matte, but I highly recommend using a dark blue-green color instead, I look forward to seeing what color you choose

Remember to always use supports 

ASSEMBLY:

I recommend starting with the belly and tail pieces, it's not very mysterious, glue and fit the piece, it's normal for there to be a slight gap between the two yellow body pieces, press firmly on the tip of the tail to make it tight, and then insert the yellow flame piece with more glue, followed by the red part

Then turn the figure upside down to see the top part of the mouth, you will see some slight holes, that's where the fangs should go, and then you can add the tongue, it should fit perfectly, 

The foot claws are not very mysterious, add glue, fit the piece and press to level it, you can press it against a table to ensure it's flat

The Eyes, as in the Squirtle model, you must assemble the 4 pieces beforehand and then insert them into the head, it usually offers resistance, press a little and it will fit without further problem,  

LUGIA AND SHADOW VER. ARE ALREADY AVAILABLE : https://makerworld.com/en/models/2734472-lugia-chibi-shadow-lugia#profileId-3031259

If you want to sell physical prints of my designs, you can get a commercial license on Patreon.
You can also support me there so I can keep creating and uploading new models: www.patreon.com/cw/Atseini 💙