Poker or Casino Chip Container

Hi everyone,

this is a small container for Casino or Poker chips with the default measurement of 39x3.5mm.

No more need to carry big poker cases with lots of unused stuff around! Just throw an amount of containers equal to the number of players into your bag and you're good to go!

The container holds 40 chips and has marks at every ten chips for easy sorting and the following common nomination in mind.

• 10x value 5
• 10x value 10
• 10x value 20
• 6x value 50
• 4x value 100

A single container uses just under 40 grams of filament, including the cap. Everything has been designed to print completely without supports or ugly overhangs.

While this model DOES print on a bedslinger and 9 of them even fit on a single A1 mini bed easily, I recommend using a Core-XY printer or slowing the print down in order to reduce wobble caused by the thin walls of the container.

Recommended settings for strength and reduced material use:

• any PLA
• 5 top shell
• 3 bottom shell
• 2 wall loops
• 10% Gyroid infill
• avoid crossing walls