TrueRC X-AIR MK2 Antenna mount for HDZero

I designed these because the stock mounts that used double sided tape were not holding very well and the antenna kept popping off. These are meant to be printed flat face down and angles of the goggle mounts are not quite 45 degrees, but if printed off a bambu printer it should be no problem without supports. This design incorporates a 2 piece setup where the antenna sandwiches between the 2 parts that clip together as a snapshut enclose that makes the stay on the goggles without the risk of the antenna popping off when taking in and out of a bag or just handling in general.