Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
56 min
1 plate
Open in Bambu Studio
Boost
2
9
0
0
7
5
Released
Description
- Update - Now contains a version with a small rear cutout to allow access to the rear buttons
Simple to print enclosure for the Badger2040, this enclosure allows power and the lanyard connection from the sides. If you also print the sliding door then it will also hold a small LiPo battery inside meaning no Velcro is needed to hold it in place.
This was created for my purposes, but I'm guessing other people may want this design too.
4xM2 screws and no nuts required.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (0)