Search models, users, collections, and posts
HSW Bottom Bracket
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
20 min
1 plate
Higher bracket, 0.2mm layer, 6 walls, 25% infill
42 min
1 plate
Open in Bambu Studio
Boost
54
181
23
1
173
120
Released
Description
A simple bracket that attaches a honeycomb storage panel to the bottom of the Bambu Lab X1 (maybe P1 as well) printer when using the Babo duo honeycomb riser.
The honeycomb panels were attached to the riser using the HSW back to back honeycomb hollow connector.
This bracket goes at the bottom and it should clip underneath the side of your printer to prevent the panels from moving around. I left a little extra space between the bracket and the side of the printer to put a thin piece of felt so the bracket won't scratch the printer.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (23)