Search models, users, collections, and posts
BENCH CLAMPS for milling / sanding / CNC
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
2.3 h
1 plate
Open in Bambu Studio
Boost
11
53
0
0
18
5
Released
Bill of Materials
List other parts
- vite con dado M8 x 2:
Description
Content has been automatically translated.
I made these clamps to secure workpieces to the workbench using an MDF board with 20mm holes.
The pieces are completely independent, so they adapt to any size.
The stop has a higher side (approx. 21mm) and a lower side (approx. 10mm) so it can also adapt to thinner boards.
You just need M8 screws with nuts (recommended screw length at least 50mm), and by tightening the screws even by hand, you already get an excellent grip with just two clamps. However, you can print as many as you want for a better grip.
I recommend placing a small piece of scrap wood in front of the screw to avoid damaging the workpieces.
Boost Me (for free)
IF YOU LIKED THE PROJECT, LEAVE A BOOST!!
REMEMBER TO ACTIVATE SUPPORTS!
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)