Print Profile(1)
Description
This is a cool piece of wallart!
This is a hueforge print.
You can print it without an AMS!
Hotend: 0,40mm
Print time: 2:07h
Filaments Used:
PLA Sunlu Meta Black
PLA Sunlu Meta Grey
PLA Sunlu Meta White
Filament swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Grey
At layer #14 (1.2mm) swap to White for the rest.
Slicer instructions:
- layer height 0,08mm
- initial layer height 0,16mm
- sparse infill 100%
- sparse infill pattern “rectilinear”
Before printing, make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For build plate adhesion, apply a thin, even coat of your preferred adhesive. I repeat the process every 5-6 prints.
Bad build plate adhesion is not related to the model.
Please check out my other models https://makerworld.com/en/u/1597610120 and leave me a like and a decent rating if you were satisfied. Thank you in advance!
Have a look at my other models here: SaVo3D | Home - MakerWorld
Boost Me (for free)
If you liked the model and found it helpful, I’d really appreciate it if you could give it a boost! It makes my day and helps make up for the time I spent making sure you had a great printing experience. Thanks a lot in advance!
Membership
Do you want to sell physical prints of my models? Join my commercial license program!
Fix adhesion-related printing errors by washing the build plate
Bambu Lab Textured PEI Plate Cleaning Guide | Bambu Lab Wiki
License
Comment & Rating (21)