Jaguar Car Bonnet (Hood) Ornament - Free 3D Print Model

Search models, users, collections, and posts

TrainForge 3D

Art>Sculptures

IP Report

Print Profile(1)

All

P1S

H2S

P1P

X1E

H2D

X1 Carbon

H2C

A1 mini

H2D Pro

P2S

X2D

A2L

0.08mm layer, 2 walls, 50% infill

Designer

3.1 h

1 plate

4.4(9)

Open in Bambu Studio

Boost

192

306

101

Released

Description

My version of the Jaguar car bonnet (hood) ornament. It is sized similarly to the actual ornament mounted on older Jaguars. The base is longer to allow it to stand by itself. Not intended to be mounted on a car … just a nice display item.

The displayed model was printed on my Bambu P1S in PLA Silk (silver). The layer height is 0.08mm with a 50% infill (gives a bit of weight) and is oriented vertically for a good finish on the back of the jaguar. Supports are needed for the front legs and in the mouth. Removing the supports from the mouth is a bit fiddly. Use a needle file to push out any stubborn bits.

NOTE: The 3mf file has the “Slow down by height” speed option activated in Bambu Studio to avoid any adhesion problems because of the vertical orientation. If you have an adhesion failure towards the top of the model when printing slowing down the print even further should solve it.

Comment & Rating (11)

@user_679363646

Print Profile

0.08mm layer, 2 walls, 50% infill

Now yes, I would like to make it bigger

(Edited)

The profile uploader has replied

Show original

@user_4043990530

Sorry about your failures - have printed this model many times without your type of failures. I haven't had any complaints from other downloaders. Could be wet filament or the brand. My silver Jaguar was printed with Sunlu Silk PLA+. Also try slowing down the print speed as this can be an issue on tall prints. The 3mf has the SLOW DOWN BY HEIGHT set, did you use the 3MF file or the STL? Hope this helps.

(Edited)

@user_679363646

I am going to set it to minimum speed (9h 30m). Bambu Lab A1 printer. Let's see if I get lucky, the other times it was at the next speed, the one that comes by default

Show original

@PinchyP

Boosted

Print Profile

0.08mm layer, 2 walls, 50% infill

printed in pla silk champagne , awesome print looks amazing , temp i set it at 230 degrees and slowed outer wall speed to 50 to achieve champagne highest gloss setting . love it