EVA Entry Plug Cockpit (for Nendoroid Good Smile)

Find GSC Huggy (EVA series) wearing a combat suit daily strange? No worries, this model meets your needs!

This is a model I made while learning, please point out any issues, currently tested with two Asuka figures

I used Bambu Lab gray PLA Matte and red PLA Lite filament and a cylindrical 3x3mm magnet

Installation Tutorial

1. Clean the build plate, 0.08mm layer height is recommended for the main body, and 0.20mm layer height with 4 walls for the base

2. Wait for printing…..(Asuka wishes you no spaghetti!!)

3. Remove supports (Be careful when using sharp tools)

4. Sanding (Optional)

5. Install the side wings

6. Install the base (Requires a bit of force, just push it all the way in)

7. Install the magnet (Optional) it will be more secure

Note: when installing the magnet, the side facing the figure should be able to attach to the screw in the middle of the figure's magnet!!! Do not attach it to the magnet next to it!!

Press the magnet into the model (You can attach it to some metal tools first before pressing it in)

8. Place the figure on top

9. Enjoy Asuka's stunning beauty

Thank you for downloading and printing this model, if it helped you, please support me, thank you