Sweet Tooth Candy Bowl

Sweet Tooth Candy Bowl

Sink your teeth into Halloween fun with this spooky vampire fang candy bowl! Perfect for holding your treats, tricks, or midnight snacks. This oversized chomp is sure to bite back when someone reaches for the candy!

Assembly Instructions:

•  Recommend PLA or PETG for easy printing.
• Use 0.2 mm layer height for detail and a 10–15% infill (it’s already sturdy).

1.   Print both parts — the Top Mouth (fangs) and Bottom Bowl (lower teeth).
    
2. Alignment: Line up the top and bottom so the fangs interlock slightly — the curvature should match seamlessly.

3. Attachment Options:
    

   • Loose fit if printed to scale (they align loose).
   • Or use a dab of hot glue / 3D pen weld / double-sided tape if you want it permanently fixed.

    

4. Done! Fill with your favorite candies, spooky treats, or even LED lights for extra Halloween vibes.

Print Tips:

• Supports: Minimal (for the top fangs only)
• Bed Adhesion: Brim or textured plate recommended
• Print Time: ~10 hrs total (depending on scale)
   

Tagline:

“Beware the bowl that bites back!”