Search models, users, collections, and posts
Playmobil Crane Gearbox
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
13 min
1 plate
Open in Bambu Studio
Boost
20
43
1
0
35
6
Released
Description
Content has been automatically translated.
My nephew's Playmobil crane (RC Crane 70441) gearbox was broken, so I ventured to create a replacement. Here is the result.
The gears fit very tightly. If more than the two shown in the picture are needed, the hole diameter in the slicer must be slightly enlarged again to maintain mobility, otherwise the gearbox will block. If only two gears are defective, as in my case, then only those two gears need to be printed.
The gears were printed with SUNLU Highspeed PETG
Have fun playing!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)