Sling Keeper - Brute Force Creations

Inspired by Sling Kontrol V1.1 from Qwerm who was inspired by a version from SubverTech.  

• I designed my version so that no hardware is required.  
  • Uses 1/8" shock cord
  • Rather than using screws to secure the cord, you just tie the ends in knots and tuck them into the pocket I designed.
• I have included 4 different files.  
  • Standard file contains all pieces to the unit including an alternate version of the latch. 
    • Standard version works for a nice tight fit for me.
    • It is tight but you should be able to snap it on (I just slide mine over the end)
  • For additional clearance on the other files, I offset the face of the interior dimensions by the specified amount.  
• These should be printed on their side for maximum layer strength and no supports.

I think I am far enough removed from SubverTech's version but want to give credit as I actually think theirs is a bit nicer.  Check them out if you want to purchase one.

https://subrevtech.com/product-category/sling-control/