Skeleton Fountain with moving water

IMPORTANT: READ BEFORE PRINTING

• The cauldron must be printed at 100% infill to hold water without leaking.
• The cauldron should be printed in two colors. The bottom part should be translucent so light can pass through.
• You will need glue to assemble some parts.
• DO NOT REMOVE NEGATIVE PARTS.
• Be patient when removing supports – adjust them to your liking if you know what you’re doing.
• A LED light is required – I used LED001 from Bambu Lab.
• A water pump is required (I used a small aquarium pump). The PUMP MUST BE SUBMERGED; it cannot run dry or it may burn the motor.
• A silicone tube is required for the water to circulate.

And now, the spooky part:

A mischievous skeleton decided to play sorcerer’s apprentice, and by endlessly pouring potions, he created an eternal magical loop! With rattling bones and bubbling lights, the cauldron comes alive, shimmering with flowing water as if an infinite potion is brewing in the shadows.

Print this model, gather the secret ingredients (glue, LED, pump, and a little wizard’s patience), and watch your Halloween turn into a living show of magic and mystery.

May your prints be flawless, may your water never stop flowing, and may your Halloween be filled with spooky fun and enchanted creations. 🦴✨🎃