Search models, users, collections, and posts
Toilet seat grommet / rubber
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 70% infill
Designer
24 min
1 plate
Open in Bambu Studio
Boost
4
6
1
0
9
8
Released
Bill of Materials
Bambu Filaments
Select all
Description
I made a grommet for my Villeroy & Boch toilet seat, that was sliding the seat and eventually totally released the seat.
This is my first upload, so I hope I did it right.
The grey part was the original part that failed, I chose to redesign it with thicker walls and a slope to the lower part, so it has a snug fit. The picture that shows the underside of the toilet is where it has to be installed; on top of the metal spacer.
I used eSUN TPU 95A with a 70% grid infill.
(as you can see in my pictures, I had some stringing but it didn't bother me as it's going to be used on the underside of a toilet bowl. I used Bambu TPU95A settings.)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)