Search models, users, collections, and posts
2-Compartment Weekly Pill Organizer
IP Report
Print Profile(1)
0.2mm layer, 5 walls, 75% infill
Designer
59 min
1 plate
Open in Bambu Studio
Boost
10
37
7
1
43
4
Released
Description
This model was designed for people who take pills two times per day. It was printed on a Bambu P1S with an AMS, using Basic PLA and PLA Support filaments. The included photos show how to assemble it after printing. The parts will be a little tight at first but will loosen up after several open/close and insert/remove cycles. I've used my pill organizer for several months and it's still operating flawlessly. Note from the photos that the AM lids go on the side of the pill container base with the indentation on it. The PM lids go on the side of the container with the raised bump. Start with the lids upside down when inserting them.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (7)