Search models, users, collections, and posts
Sorgenfresser Statue/Figure
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
13.7 h
1 plate
Open in Bambu Studio
Boost
3
1
2
0
0
0
Released
Description
Content has been automatically translated.
What do you get when you mix 13 hours of print time, 0.4 mm layer height, and a good dose of imagination?
👉 A 25 cm tall Sorgenfresser, straight from the Bambu Lab A1 – megalomaniacal, hungry, and ready to digest your emotional junk.
🎨 Colors? Variable.
Every Sorgenfresser is unique. Whether green like in the picture or in a brightly colored mix – your AMS changes, you decide. The teeth? Optionally yellow with shame. The eyes? Always a bit... off. But charming.
🛠️ Print Setup:
- Duration: ~13 hours
- Layer Height: bold 0.4 mm – visible, intentional, distinctive
- Size: 25 cm tall
- Filament: PLA, multicolored
- Infill: 15–20 %
- Printer: Bambu Lab A1 with AMS
- Slicer: Bambu Studio
📦 Printed in one go, no post-processing needed. Baseplate with the inscription SORGENFRESSER is directly integrated – not a gimmick, but a statement.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (2)