Search models, users, collections, and posts
Microphone Holder for 3/8" Tripod (e.g., Sennheiser)
IP Report
Print Profile(1)
0.2mm layer, 4 walls, 35% infill
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
6
29
1
0
29
13
Released
Description
Content has been automatically translated.
Simple microphone holder (here for a Sennheiser ew100/ew300 cordless microphone)
It fits a tripod with a 3/8" inch thread.
The microphone mount is conically designed (front: 38mm, back: 36mm)
As accessories, you will need an M6 nut, an M6x20 hex screw, and some superglue. The screw is embedded in the wheel and the washer is placed on top. Fix everything with a little superglue. The nut is embedded in the tripod mount. Ideally, fix this with superglue as well.
Note: The screw shown in the photo is too long. I shortened mine to fit.
Print settings:
Material: - depending on needs, I used ASA
Infill: 35%, Cross-Hatch
Nozzle: 0.4mm
Walls: 4
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)