Expandable Tin/Aviation Snips Holder for openGrid

This expandable holder for tin snips/aviation snips was inspired by this model (https://www.thingiverse.com/thing:7062947)

I used the openGrid KV Fitting Base.

This design will overlap into the next openGrid unit for the end plate already, since every unit is 28mm wide, so I put the fitting base flush so it will print without supports.

The rings are hardly necessary to keep it attached to the openGrid, but I included them as well.

You can print as many of the snips holder module (Plate 1) as you need and then finish it off with an end plate (Plate 2).

Fusion file is included (most things are parameterized)

V1.1 added some pressure fit bumps to make the plate fit better