Fanatec CSL DD Befestigung - Free 3D Print Model

Search models, users, collections, and posts

Speddy99

Hobby & DIY>Other Hobby & DIY

IP Report

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 3 walls, 25% infill

Designer

2.4 h

1 plate

5.0(12)

front 3mm higher. more tilt

Designer

2.5 h

1 plate

5.0(1)

Open in Bambu Studio

Boost

167

246

144

Released

Description

Befestigung für Fanatec CSL DD.

Halterung wird mit M6 Schrauben an der Fanatec CSL DD befestigt.

Anschließend kann die Base komplett mit M8 Schrauben am 40*80 Aluprofil mit Nutsteinen befestigt werden.

Attachment for Fanatec CSL DD.The bracket is attached to the Fanatec CSL DD using M6 screws.The base can then be completely attached to the 40*80 aluminum profile with sliding blocks using M8 screws.

simracing

fanatec csl

csl dd

Comment & Rating (21)

@roor

Print Profile

0.2mm layer, 3 walls, 25% infill

Good print, the nozzle was rubbing a bit on my A1, but it's not "important" I added more infill just in case Thanks for sharing!!!!!!!

The profile uploader has replied

Show original

@roor

@Speddy99 Good morning!!! would it be possible to make it with a little more inclination? 20 degrees or 25 or both? 😅 Thank you!!!!

Show original

@Speddy99

Replying to @roor :

I can draw something, but what height should I have at the front, in millimeters? Should I keep the other dimensions

Show original

@roor

Replying to @Speddy99 :

add 3mm more to the front, where the base rests, so that it has more tilt, the rest of the base is the same, it is so that the steering wheel is more raised upwards

(Edited)

Show original

@roor

Print Profile

front 3mm higher. more tilt

Now it's perfect, those extra 3mm were just what I needed to make it to my liking I've put 30% infill instead of the 15% that the file had Thank you for attending my request and adding those mm 🙌🏼 Thank you!!!!!!

(Edited)

The profile uploader has replied

Show original

@Speddy99

:-)

@ptitomgab

Print Profile

0.2mm layer, 3 walls, 25% infill

Print in PETG CF, it is perfect

Show original

@DSxxxxxxxxxxxx

Print Profile

0.2mm layer, 3 walls, 25% infill

genau der richtige Winkel und die Anordnung der Löcher ist super. Ein bisschen eng waren die Löcher. M6x12 ist eine super Größe für die Nutensteine der DDpro base. exactly the right angle and the arrangement of the holes is great. The holes were a bit tight. M6x12 is a great size for the T-nuts on the DDpro base.