Car Seat Back Storage Box/Trash Can

This chair back storage box is suitable for chair backs with a panel where the panel thickness is less than 6mm

The support for the back clip needs to be removed gently, as forcibly removing it can easily break the clip. When removing it, you can use pliers to break off the edges on both sides of the support. Then, gently wiggle it left and right, and lightly lift it up and down, and the entire support will come off. Remember not to use too much force. Even if the support cannot be removed entirely, it's better to remove it slowly piece by piece

If you are truly worried about the support being difficult to remove, you can adjust the top Z distance to 0.2

By the way, the model is relatively tall, so it is not recommended to adjust the printing speed parameters